Dynamic IPsec Between a Static ASA Hub and Dynamic ASA Spoke

[LOUIS BOUCHARD]

anyone can give me an hint on the sample configuration for both hob and spoke.

I have found what I need between and ASA hub and IOS spoke

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00807ea936.shtml

but I also need between two ASAs

[acomiskey]

The easiest way I found to accomplish this is to use the DefaultL2LGroup on the hub ASA. On the spoke ASA you will use a tunnel group equal to the ip of the hub ASA. Post your configs if you need a hand.

Hub ASA

tunnel-group DefaultL2LGroup ipsec-attributes

pre-shared-key *

Spoke ASA

tunnel-group ipsec-attributes

pre-shared-key *

Configure the rest the same way you would any other L2L tunnel.