03-01-2004 09:26 PM - edited 03-09-2019 06:36 AM
A Catalyst 6509 with two SUP2 and two Firewall Module,Two Firewall Module is failover. Dynamic Translation¡¢Static Translation and Static route were configed on Firewall.The switch was rebooted because of the power was down abruptly.After switch's reboot was finished all connection status were shown right.The Static Translation and Static route were right also,but the dynamic translationg is not work.Show Xlat can list the Pat entries,but PAT was not work in fact.We rebooted the firewall module with command,but no effect?The firewall was recovered after we clear all configuration on firewall and reconfiged it.
What is the reason of this instance,what should we do next time.
03-05-2004 11:43 AM
Did you try the clear xlate command. That should clear all the existing translations.
03-07-2004 04:30 AM
I tried clear xlate severay time,but I feel this command invalid.After execute this command all the translated entry were still exist.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: