Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

dynamic virtual tunnel interface on 2821

I tried to configure a dynamic virtual tunnel interface on a Cisco 2821 with release 12.4(9)T1 advanced ip services, aiming to terminate VPN client ipsec tunnels on it.

The feature is supported by this software release. Documentation says:

- enter configuration

- configure a virtual-template interface

- type "tunnel mode <mode>"

but the router does not accept this command.

Any hint?

Thank you in advance.

Denis

1 REPLY
Silver

Re: dynamic virtual tunnel interface on 2821

120
Views
0
Helpful
1
Replies
CreatePlease to create content