Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Easy VPN Pix 501 to VPN 3000

I am very new to this...

I am trying to connect a remote pix 501, through a cable modem, to my vpn 3000.

I can connect the vpn 3000 fine with the client software, I have made a group for remote hardware access,

when I go vpnclent enable, I can get no whate on the pix, not through the tunnel or the inetrnet.

The vpn 3000, show no event of the pix even trying to connect: any ideas, the host ip of the vpn concentrator is correct in the pix.

1 REPLY
Bronze

Re: Easy VPN Pix 501 to VPN 3000

This document talks about IPSec between VPN 3000 and Pix,

http://www.cisco.com/en/US/products/hw/vpndevc/ps2284/products_configuration_example09186a00800949d2.shtml

This might give you a good idea

82
Views
0
Helpful
1
Replies
CreatePlease to create content