I'm trying to use a Cisco 837 with EZVPN to connect to a VPN 3000 Concentrator. I'm attempting to authenticate with XAUTH using SDI (SecureID tokens) on the VPN 3000 Concentrator. Establishing the connection is simple enough; I cannot, however authenticate with XAUTH. I am prompted for authentication on the router, but when I input the username and pin w/ token number the connection simply times out. In the release notes for Easy VPN Remote Phase II, is specifies that Interactive Hardware Client Authentication on the VPN 3000 Concentrator is not supported. This is, unfortunately, required for SDI authentication. Is there any plans to add this functionality or a possible workaround for this issue? Thanks.
Re: Easy VPN with Cisco 837 and VPN 3000 Concentrator
Thanks. I checked, and unfortunately the 831 (I meant 831 when I typed 837 before) only supports up to 12.2(13)ZH1. Is there any other code I can use that has this functionality in it? If not, when can I expect to see a new version that has this feature? Thanks.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
[toc:faq]Introduction:This document describes details on how NAT-T
works.Background:ESP encrypts all critical information, encapsulating
the entire inner TCP/UDP datagram within an ESP header. ESP is an IP
protocol in the same sense that TCP and UDP are I...