Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

EIGRP redistributing

Hello there,

I have the diagram attached.

I was planning to use IGRP between the 3825 and the branches, but i noticed that the PIX does not supports EIGRP.

Do you have any advice how can i use EIGRP on the PIX?????

if it's not supported, should i use OSPF or Static???

regards

Fady

  • Other Security Subjects
1 REPLY
New Member

Re: EIGRP redistributing

Hi Fady,

You can do several things as I see it.

You can run EIGRP between your branches and the 3528 router, and the run RIP or OSPF between the PIX and the 3828 router. Redistributing EIGRP into the routing protocol you choose.

You can run EIGRP on all equipment, and use a GRE tunnel to get it throug the PIX.

You can also use OSPF on the entire network and put the PIX into the OSPF routing processes.

Kind regards

87
Views
0
Helpful
1
Replies
This widget could not be displayed.