Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Embryonic connection limit has been exceeded

ASA5550:

Initially the embryoinic limit was set to 2000, this was then removed but the log stil shows the limit being exceeded - as if it is still set to 2000.

Is there a way of forcing this back to 0 (unlimited)

2 REPLIES
Cisco Employee

Re: Embryonic connection limit has been exceeded

please issue the command :

cl xlate

you should be all set.

the reason:

the existing translations built in the firewall are still following the embryonic limits.

rule of thumb:

after any change in nat,global and static,please issue " cl xlate " once so that the new setting come in the picture,then and there.

Regards,

Sushil.

Cisco TAC.

Community Member

Re: Embryonic connection limit has been exceeded

Hello,

Try issuing the

clear local-host your_local_ip

I had the same problem the clear xlate wasn't working.

Regards,

jj

139
Views
0
Helpful
2
Replies
CreatePlease to create content