Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Enabling Multicast

Sorry for the dumb question but I have a multicast feed from BT they already have enabled it on the routers. I have a Pix-525 between them and my network, all the switches have IGMP already enabled on them but I'm unable to see the multicast feed. I'm assuming I need to enable IGMP on the Pix as well. What would I need to do to do that? Thanks in advance....

  • Other Security Subjects
1 REPLY
New Member

Re: Enabling Multicast

Without any effort you can tunnel the mulitcast traffic

http://www.cisco.com/en/US/products/hw/vpndevc/ps2030/products_configuration_example09186a00800943fe.shtml

of with PIX 7.0 you can configure it as IGMP proxy agent or full blown PIM router. Please refer to Section 3-4

Cisco ASA and PIX Firewall Handbook

* By David Hucaby.

100
Views
3
Helpful
1
Replies
This widget could not be displayed.