Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Error: can not add name attribute on PIX 6.01 and 6.11

After upgrading pix firewall to 6.01 or 6.11, I get the following message: Error: can not add name attribute. I think it is a cosmetic message. Anyone can explain this error?

  • Other Security Subjects
2 REPLIES
Cisco Employee

Re: Error: can not add name attribute on PIX 6.01 and 6.11

Where does this message appear?

I'd advise calling TAC and opening a priority 4 case (informational) when you see something like that.

Liberty for All,

Brian

New Member

Re: Error: can not add name attribute on PIX 6.01 and 6.11

After some investigation, I found out that only happens on PIX firewall with activation key providing VPN access. I have another firewall with no VPN capabilities and it does not show any error messages. I have tested the firewall with 6.11 and I did not see any issues at all. It is solid. I have a TAC opened with Cisco. I will confirm the results later on.

142
Views
0
Helpful
2
Replies
This widget could not be displayed.