Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Error: Cannot translate ip protocol tcp to ip protocol ip

This error message was found on a pix506 when configuring policy nat.

PIX506(config)# show ver

Cisco PIX Firewall Version 6.3(5)

Cisco PIX Device Manager Version 3.0(4)

Compiled on Thu 04-Aug-05 21:40 by morlee

PIX506 up 2 days 20 hours

Hardware: PIX-506, 32 MB RAM, CPU Pentium 200 MHz

Flash i28F640J5 @ 0x300, 8MB

BIOS Flash AT29C257 @ 0xfffd8000, 32KB

0: ethernet0: address is 0004.2746.1a50, irq 11

1: ethernet1: address is 0004.2746.1a51, irq 10

Licensed Features:

Failover: Disabled

VPN-DES: Enabled

VPN-3DES-AES: Enabled

Maximum Physical Interfaces: 2

Maximum Interfaces: 4

Cut-through Proxy: Enabled

Guards: Enabled

URL-filtering: Enabled

Inside Hosts: Unlimited

Throughput: Limited

IKE peers: Unlimited

This PIX has a Restricted (R) license.

Serial Number: 480500233 (0x1ca3da09)

Running Activation Key: 0x2182a733 0x36a897ca 0x915734b2 0xc21beebc

Configuration last modified by enable_15 at 10:36:18.720 PST Wed Nov 15 2006

PIX506(config)# PIX506(config)# access-list http permit tcp host 10.15.1.106 host 204.50.71.1 eq www

PIX506(config)# static (inside, outside) 65.39.139.30 access-list http

ERROR: cannot translate from IP protocol tcp to IP protocol ip

PIX506(config)#

I read cisco document, 6.3(5) should support policy NAT, I don't know why it didn't work on my machine. Please help me, Thanks

Benny

2 REPLIES
Gold

Re: Error: Cannot translate ip protocol tcp to ip protocol ip

can you try

PIX506(config)# static (inside, outside) tcp 65.39.139.30 http access-list http http

M.

New Member

Re: Error: Cannot translate ip protocol tcp to ip protocol ip

Yes, It did accept this command:

static (inside, outside) tcp 65.39.139.30 www access-list http 0 0, But I'am not sure it works, Why it was not same as the document said. Thank you

Benny

327
Views
0
Helpful
2
Replies
CreatePlease to create content