Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Error message after update to S26

I got an error message while updating to S26. The update program reported a successful update, did a nrstatus und printed following error message after that:

./IDSk9-sig-3.1-2-S26.bin[87] test: argument expected

The sensor seems to work perfect. Do I have to worry about this message ?

1 REPLY
Cisco Employee

Re: Error message after update to S26

Fortunately you can ignore this error message.

At the end if the installation it checks to see IDM shoudl be restarted.

If IDM had been running then the check will work properly and IDM will be restarted.

If IDM was configured to be off then the test should return false and IDM would not be restarted.

The test, however, fails with a blank arguement if IDM had not been running. This results in the error that you are seeing. Fortunately this also the last thing that happens in the installation. SO you are fine, and can feel confident that the installation will work just fine for you. I will write up a DDTS issue and hopefully have this very minor issue fixed for S27.

Thank you for pointing out this problem to us.

marco

104
Views
0
Helpful
1
Replies
CreatePlease login to create content