Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Error message in hub-and-spoke VPN

I keep losing the tunnel I have setup between my 3015 VPN device and a non-Cisco device. I am trying to force all traffic from a small office over the VPN so I can control Internet access centrally. The tunnel comes up but then dies. The error message I'm receiving on the Cisco end is leading me to believe that I need to make modifications to the 3015 configuration. The error message is:

Tunnel rejected: Policy not found for Src:0.0.0.0, Dst: 0.0.0.0

1 REPLY

Re: Error message in hub-and-spoke VPN

Since there has been no response to your post, it appears to be either too complex or too rare an issue for other forum members to assist you. If you don't get a suitable response to your post, you may wish to review our resources at the online Technical Assistance Center (http://www.cisco.com/tac) or speak with a TAC engineer. You can open a TAC case online at http://www.cisco.com/tac/caseopen

If anyone else in the forum has some advice, please reply to this thread.

Thank you for posting.

113
Views
0
Helpful
1
Replies