Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

Error message on Updating Sensor with IDSk9-sp-3.0-5-S17.bin

Sucessfully Updated sensor with IDSk9-sp-3.0-4-S16.bin. Could not updated sensor with IDSk9-sp-3.0-5-S17.bin. Both files were downloaded in the same manner and transfered to the sensor.

Here is the following error message:

# ./IDSk9-sp-3.0-5-S17.bin -I

Invalid character (0x0) on line 39935

No end line

tar: read error: unexpected EOF

chmod: WARNING: can't access ./SEN305SP/install/ids-patchinstall

Files were downloaded from Cisco's http download site. Downloaded the S17 release twice same error occurs. Is there a problem with the file?

3 REPLIES
Community Member

Re: Error message on Updating Sensor with IDSk9-sp-3.0-5-S17.bin

I had no problems using all of the files off of Cisco's site, including S17..

Community Member

Re: Error message on Updating Sensor with IDSk9-sp-3.0-5-S17.bin

Verify checksums for the file you downloaded match the values listed on the software download page to make sure the file was tranferred successfully.

Community Member

Re: Error message on Updating Sensor with IDSk9-sp-3.0-5-S17.bin

Thank you, for the confirmation that the file worked for someone. I re-downloaded the file and ensured the checksums matched. It executed as expected.

93
Views
0
Helpful
3
Replies
CreatePlease to create content