Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Error when sending router config

I have a Cisco 1751 Router with IOS 12.2. Everytime I try to send a configuration from ConfigMaker to the router I get the following error:

Context: Global configuration mode

Command: vpdn enable

Error: ^

Invalid input detected at '^' marker

All I am trying to do is setup NAT on the router so clients dialing into thier own ISP can VPN into our network. Can anybody help?

4 REPLIES
New Member

Re: Error when sending router config

You probably don’t have the right IOS installed. You have to have the IPSEC IOS for that feature. Use IOS upgrade planner to determine the right one for your needs.

New Member

Re: Error when sending router config

Thats what I was told before so I downloaded the newest IOS with IPSEC 12.2 and I am still getting the same error.

Cisco Employee

Re: Error when sending router config

Hi,

Please let me know the image you are using. (Just give me the output of show version Also can you post this mail to configmaker@cisco.com??

Thanks.

New Member

Re: Error when sending router config

Here is the output file ( I also sent it to configmaker@cisco.com)

RTRouter#show version

Cisco Internetwork Operating System Software

IOS (tm) C1700 Software (C1700-Y-M), Version 12.2(4)T, RELEASE SOFTWARE (fc1)

TAC Support: http://www.cisco.com/tac

Copyright (c) 1986-2001 by cisco Systems, Inc.

Compiled Fri 28-Sep-01 02:10 by ccai

Image text-base: 0x800080E0, data-base: 0x80738B80

ROM: System Bootstrap, Version 12.2(1r)XE1, RELEASE SOFTWARE (fc1)

RTRouter uptime is 5 days, 16 hours, 6 minutes

System returned to ROM by reload

System image file is "flash:c1700-y-mz.122-4.T.bin"

cisco 1751 (MPC860P) processor (revision 0x600) with 24576K/8192K bytes of memory.

Processor board ID JAD054810TG (1213955261), with hardware revision 0000

M860 processor: part number 5, mask 2

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

1 FastEthernet/IEEE 802.3 interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read/Write)

Configuration register is 0x2102

90
Views
0
Helpful
4
Replies
CreatePlease to create content