How does one change event logging for an IDS just to be "Commands" from the Policy Manager?
I have made this change on the IDS sensor using the browser interface, however, it has gone back to "Alarms", "Errors" and "Commands." I believe the change happened when I "Applied" IDS changes in the Policy Manager. (?)
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...