Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ezyvpn client to pix redundancy

what mechanism would you use in a pair of pix's being used as headend vpn ezyvpn servers in order to have redundancy for ezyvpn clients.... How would the pix's dynamically advertise the routes for the clients they have acquired? The pix's in question are geographically separated over a wan so are not running in failover mode.

2 REPLIES
Cisco Employee

Re: ezyvpn client to pix redundancy

Hi Dickler,

Yes you might have a solution if you have PIX firewalls as EzVPN clients, in the vpnclient command set you can define "vpnclient server ip_primary [ip_secondary_1 ip_secondary_2" which means The vpnclient server ip_primary ip_secondary_1[ip_secondary_2 ... ip_secondary_10] command enables you to create a backup VPN server list on the VPN client.

Additional details can be found at:

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_command_reference_chapter09186a00801727ae.html#1048520

Regards,

Aamir Waheed,

Cisco Systems, Inc.

CCIE#8933

-=-=-

New Member

Re: ezyvpn client to pix redundancy

thanks for the response. However, the question is not how to configure it on the client but how to tell the current server to advertise the route to the client network.

92
Views
0
Helpful
2
Replies
CreatePlease login to create content