Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Factory reset through ASDM to ASS 5510

I did a factory reset on a 5510 that we are currently testing before deploying and now I can not get back in. No console cable, no factory dhcp addressing on the management interface. NADA. Any suggestions??

2 REPLIES

Re: Factory reset through ASDM to ASS 5510

Hi,

The inside interface of the ASA is assigned 192.168.1.1 by default. Use cross-over cable to connect it direct to your laptop, or use straight cable through switch/hub.

Use your web-brower (https) to start configuring the box again.

http://www.cisco.com/en/US/partner/products/ps6120/products_getting_started_guide_chapter09186a00805e2928.html#wp1035910

Hope this helps.

Rgds,

AK

New Member

Re: Factory reset through ASDM to ASS 5510

The ASA5510 and the SSM-10 module has now been reset to its factory default configuration. Three Cisco tech and the last one was able to help me.

319
Views
0
Helpful
2
Replies
CreatePlease to create content