PIX failover both devices should be the same related to HW. What on the other hand is better or more useful? Failover with Cisco Primary-Secondary cable or throught eth/fasteth. interfaces of PIX itself?
If the firewalls are within 6 feet of each other then the serial cable is a better bet for non stateful failover. This is because the standby can detect if the primary has lost power which is not detectable using an ethernet cable so failover takes longer. Also if you use an ethernet cable the switch becomes a single point of failure.
If you want to do stateful failover you have to use an ethernet cable. However this does not stop you using the serial cable for non-stateful failover as well.
yes you can. If you want stateful failover you have to use an ethernet cable, the serial cable will not do stateful failover. However you can use the serial cable for non-stateful failover and the ethernet cable for stateful failover.
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...