Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Failover Cold Standby

when show fa, it shows"Other host: Secondary - Cold Standby", when this could happen? Usually it should show "failed"

ASA# sh fa

Failover On

Failover unit Primary

Failover LAN Interface: state Ethernet0/3 (up)

Unit Poll frequency 1 seconds, holdtime 15 seconds

Interface Poll frequency 5 seconds, holdtime 25 seconds

Interface Policy 1

Monitored Interfaces 3 of 250 maximum

Version: Ours 7.2(1), Mate 7.2(1)

Last Failover at: 07:44:17 EDT Jun 19 2006

This host: Primary - Active

Active time: 1991496 (sec)

slot 0: ASA5510 hw/sw rev (1.1/7.2(1)) status (Up Sys)

Interface outside (1.1.1.253): Normal (Waiting)

Interface DMZ (172.16.1.4): Normal (Waiting)

Interface inside (172.16.101.2): Normal (Waiting)

slot 1: ASA-SSM-10 hw/sw rev (1.0/5.1(1)S229.0) status (Up/Up)

IPS, 5.1(1)S229.0, Up

Other host: Secondary - Cold Standby

Active time: 0 (sec)

slot 0: ASA5510 hw/sw rev (1.1/7.2(1)) status (Up Sys)

Interface outside (1.1.1.252): Unknown (Waiting)

Interface DMZ (172.16.1.2): Unknown (Waiting)

Interface inside (172.16.101.1): Unknown (Waiting)

slot 1: ASA-SSM-10 hw/sw rev (1.0/5.1(1)S229.0) status (Up/Up)

IPS, 5.1(1)S229.0, Up

Stateful Failover Logical Update Statistics

Link : state Ethernet0/3 (up)

Stateful Obj xmit xerr rcv rerr

General 0 0 0 0

sys cmd 0 0 0 0

up time 0 0 0 0

RPC services 0 0 0 0

TCP conn 0 0 0 0

UDP conn 0 0 0 0

ARP tbl 0 0 0 0

Xlate_Timeout 0 0 0 0

VPN IKE upd 0 0 0 0

VPN IPSEC upd 0 0 0 0

VPN CTCP upd 0 0 0 0

VPN SDI upd 0 0 0 0

VPN DHCP upd 0 0 0 0

Logical Update Queue Information

Cur Max Total

Recv Q: 0 0 0

Xmit Q: 0 0 0

1130
Views
0
Helpful
0
Replies