Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failover configuration...

Could someone with more experience than I tell me if this configuration looks correct? We do not yet have a dmz. I am concerned the secondary, Interface inside's ip is different that the primary. The 10.0.0.1 on the primary is our gateway on all our servers and it seems with this configuration, if the primary failed the secondary would take on the incorrect ip.

Any advise or suggestions are greatly welcome.

TIA

Poll frequency 7 seconds

This host: Primary - Active

Active time: 2738470 (sec)

Interface intf2 (192.168.0.1): Link Down (Waiting)

Interface outside (198.137.151.20): Normal

Interface inside (10.0.0.1): Normal

Other host: Secondary - Standby

Active time: 0 (sec)

Interface intf2 (192.168.0.2): Link Down (Waiting)

Interface outside (198.137.151.142): Normal

Interface inside (10.50.0.4): Normal

1 REPLY
Bronze

Re: Failover configuration...

I just saw the other post...

sorry

87
Views
0
Helpful
1
Replies
CreatePlease login to create content