06-24-2002 12:12 AM - edited 03-08-2019 11:05 PM
I have pix 525 with failover , when i notice that The failover pix become active most of the time especially when there are a high traffic if i switch to primary it work fine for 5 or 6 hours then switch to failover , also i configured a statefull ,
your advice is appreciated
06-24-2002 12:59 AM
when the failover occurs and the secondary device becomes active, what does the "show failover" indicate??
Use this URL for failover troubleshooting tips and more info.
http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_v50/config/advanced.htm#xtocid14
HTH
R/Yusuf
06-24-2002 01:06 AM
Nothing not normal every thing is normal and also the interfaces ar marked as normal .
06-26-2002 11:47 AM
Check the uptime "sh version" of the primary firewall. It could be that the primary firewall is reseting.
06-27-2002 03:47 AM
I was thinking like that but it doesn't make a reset at all. but I notice when I type show failover interface 6 is always marked with "test" not like other interfaces marked with "normal" , could it be the problem at this interface .
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide