Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Failover

I have pix 525 with failover , when i notice that The failover pix become active most of the time especially when there are a high traffic if i switch to primary it work fine for 5 or 6 hours then switch to failover , also i configured a statefull ,

your advice is appreciated

4 REPLIES
Cisco Employee

Re: Failover

when the failover occurs and the secondary device becomes active, what does the "show failover" indicate??

Use this URL for failover troubleshooting tips and more info.

http://www.cisco.com/univercd/cc/td/doc/product/iaabu/pix/pix_v50/config/advanced.htm#xtocid14

HTH

R/Yusuf

New Member

Re: Failover

Nothing not normal every thing is normal and also the interfaces ar marked as normal .

New Member

Re: Failover

Check the uptime "sh version" of the primary firewall. It could be that the primary firewall is reseting.

New Member

Re: Failover

I was thinking like that but it doesn't make a reset at all. but I notice when I type show failover interface 6 is always marked with "test" not like other interfaces marked with "normal" , could it be the problem at this interface .

92
Views
0
Helpful
4
Replies
CreatePlease login to create content