11-19-2006 11:26 PM - edited 02-21-2020 02:44 PM
hello netpro:
I'm testing a ipsec nat traversal,but I can't find out a detailed example on cco,for instance how to configure or troubleshooting . could you like to provide some information about it , thanks a lot.
11-19-2006 11:30 PM
Check following link
http://www.cisco.com/en/US/products/sw/iosswrel/ps1839/products_feature_guide09186a0080110bca.html
M.
hope that helps rate if it does
11-21-2006 05:56 PM
Hi m'sir ,
thank your help, I have read the document , but there is not a whole configuration about nat-t, I knew the nat-t function using udp port 4500 , I used command (debug cry isakmp and debug cry ipsec) but can't find the output that have source or destination port is 4500.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: