Our school system recently purchased a Firebox 1000 (WatchGuard). Our problem is this: We have three separate blocks of IP addresses, all of which are configured to the E0 interface on the router, which is administered by our ISP. When we initially setup the Firebox, we could get it to protect only one set of addresses (one gateway). Any tips on setting this up to protect our network under all three gateways?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...