... I can not authenticate ... I install the Cisco ACS version 4.2. And the installation and was successful but when I start the GUI Administration I enter the Windows Account (Administrator) but I dont cant authenticate ...
from the machine you installed it on, you should have a shortcut on your desktop or go to "programs, CiscoSecure ACS v4.2" use the "ACS Admin" web interface to login and it shouldnt ask for any username. once you login, go to administration control to create administrator account.
Administrators must have a Windows domain administrator account in order to log in and manage ACS services. However, Windows domain administrators cannot log in to ACS. Only administrators with valid ACS accounts can log in to ACS. For information, see the Installation Guide for Cisco Secure ACS for Windows Release 4.2 or the Installation Guide for Cisco Secure ACS Solution Engine Release 4.2.
I Installed the ACS version 4.2 in the server (logged as Administrator)
And then, I restarted the server.
From another worstation of my LAN, I opened a web browser with the web address: http://ipaddressoftheACS:2002, and it shows the GUI of the ACS, with the login textbox and I enter the username: Adminstrator (Windows) and the password of the Administrator account in the password box. And login failed.
This procedure is correct ?
Or I should do this:
In the ACS server go to ACS shortcuts, and enter the following information:
Login to the FXOS chassis manager.
Direct your browser to https://hostname/, and log-in using the user-name and password.
Go to Help > About and check the current version:
Check the current version availa...
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...