Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

floodguard on pix 525 ver.7.1(2)

Good morning I have upgrade the relase of my Pix Firewall, from 6.3 to 7.1(2)

Now I need the feature floodguard, (which I had enable on 6.3) but I don't find the CLI to enable floodguard, anyone know the right command line to active it?

I've read the link:

http://www.cisco.com/en/US/products/ps6120/products_command_reference_chapter09186a00805fba01.html

but i don't find the command about floodguard.

Any information that you can send me are welcomed.

Best Regards

Davide

2 REPLIES
Cisco Employee

Re: floodguard on pix 525 ver.7.1(2)

Hello Davide,

The floodguard command is now a deprecated command and is no longer needed. The floodguard feature is always enabled.

Please review

http://www.cisco.com/en/US/products/sw/secursw/ps2120/products_upgrade_guides09186a0080369ee2.html#wp1462575

for more info.

Hope that helps! Please rate if it does.

Thanks,

hemendoz

New Member

Re: floodguard on pix 525 ver.7.1(2)

Hi hemendoz thanks very much for your answer, now I'm reading the link that you suggested me.

Best Regards

Davide

557
Views
0
Helpful
2
Replies