Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

forget PIX "static NAT" if I Set ASA Interfaces to "same security level" ?

Hallo

I migrate our PIX enviroment to ASA at the moment

As I understood "static nat" like :

static (dmz1,dmz2) 10.0.0.1 10.0.0.1 netmask 255.255.255.255

is only needed for PIX where  I had low security --> higher

If I set all the ASA interfaces to the same security level I can forget the "static nat" for migration

Thats right ?

sincerely Alfred

1 REPLY
Cisco Employee

forget PIX "static NAT" if I Set ASA Interfaces to "same securi

Yes, you are correct if all interfaces have the same security level, then you don't need to configure "static nat".

However if you have dynamic NAT, here is more information on the same security level interface:

http://www.cisco.com/en/US/docs/security/asa/asa82/configuration/guide/nat_overview.html#wp1079261

402
Views
0
Helpful
1
Replies
CreatePlease login to create content