Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

Forwarding rule

I have 2 questions. firstly, I am using a static map to forward the packets from DMZ to inside network. Is there any other way to do this ?

Secondly , Can i use static NAT to 2 IP address from the inside network to Single IP address in the DMZ network. If so, what commands do i use ?

  • Other Security Subjects
1 REPLY
Cisco Employee

Re: Forwarding rule

Q1.

The only way to forward traffic from DMZ to inside is by creating a static translation using the static command. Note that traffic from lower level interface to a higher level interface eg from DMZ to Inside, you must have a static.

http://www.cisco.com/warp/public/707/28.html

Q2.

No, you cannot have 2 inside IP addresses assigned to a single IP on DMZ.

HTH

R/Yusuf

99
Views
0
Helpful
1
Replies