Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

FWSM 2.3.3

Having major problems with our FWSM and its ability to end connections. Our used memory continues to climb higher and higher (as the conns build, 560,000+), traffic begins to NOT pass in and out of our interfaces. Because our timeout values are NOT the default by Cisco, this is our problem until the code fixes this...anyone else running into similar problems?

2 REPLIES
Cisco Employee

Re: FWSM 2.3.3

hi,

what are your timeout values set to? Were you having the same issue with older code?

thanks

Nadeem

New Member

Re: FWSM 2.3.3

We changed our connection time and xlate time to 3hrs....yes, older code had the same problem. Memory begins to creep up day by day, and when we look at the connections "sh pc conn" at times we see 500,000+ connections...it is at this point when we start to see major problems w/traffic not passing thru our interfaces (we have 5 intf's at present).

132
Views
0
Helpful
2
Replies