Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FWSM 2.3(3)

I have a FWSM ver 2.3(3) which is licensed for 50 security context. I have looked at the PDF, on how to change from single to multiple mode. It takes the command and reboots the blade the problem is that when it comes back up it is still in single mode. Is there a step I am missing to get the FWSM into multiple mode. Even if it was a license issue, from what the PDF states I should still be able to add 2 context to the box, which I cannt do. The box does not know the context command, which I believe is the happening because it is not switching out of single mode.

2 REPLIES

Re: FWSM 2.3(3)

Hi,

It sounds weird, but try entring your 50-virtual firewall license before you enable the multiple mode:

FWSM(config)# activation-key

FWSM(config)# mode multiple

http://www.cisco.com/en/US/products/hw/switches/ps708/products_module_configuration_guide_chapter09186a00802c6418.html#wp1036419

Rgds,

AK

New Member

Re: FWSM 2.3(3)

I have tried that, but the only activation key I have is the one that is loaded on the system. Since it was all ordered at the once, the activation key has the 50 context. I tried to reload the activation key again, but it does not change since it is the same.

165
Views
0
Helpful
2
Replies
CreatePlease to create content