I'm implementing a new firewall solution based on FWSM to replace an existing old IOS Firewall. The old firewall has a policy routing rule done via route map which sets next hop router address for a given source network with match and set commands. I've tried to recreate this environment in FWSM but set statements in route-map config mode are only for "set metric" and "set metric-type" (tried in OS 2.3.3 and 3.1.1). Is policy routing unsupported in FWSM ? There is a workaround ?
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...