Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

FWSM Blades Contantly running diagnostics.

Hey I was wondering if this was normal for two FWSM blades to keep doing diagnostics over and over. It does this about every four hours.

Aug 18 10:56:24.957 AST: SP: The PC in slot 3 is shutting down. Please wait ...

Aug 18 10:56:25.121 AST: SP: PC shutdown completed for module 3

Aug 18 10:56:25.121 AST: %C6KPWR-SP-4-DISABLED: power to module in slot 3 set off (Reset)

Aug 18 10:58:03.878 AST: %DIAG-SP-6-RUN_MINIMUM: Module 3: Running Minimum Diagnostics...

Aug 18 10:58:06.526 AST: %DIAG-SP-6-DIAG_OK: Module 3: Passed Online Diagnostics

Aug 18 10:58:16.717 AST: %OIR-SP-6-INSCARD: Card inserted in slot 3, interfaces are now online

Aug 18 15:07:37.304 AST: SP: The PC in slot 4 is shutting down. Please wait ...

Aug 18 15:07:37.459 AST: SP: PC shutdown completed for module 4

Aug 18 15:07:37.467 AST: %C6KPWR-SP-4-DISABLED: power to module in slot 4 set off (Reset)

Aug 18 15:09:16.618 AST: %DIAG-SP-6-RUN_MINIMUM: Module 4: Running Minimum Diagnostics...

Aug 18 15:09:19.210 AST: %DIAG-SP-6-DIAG_OK: Module 4: Passed Online Diagnostics

Aug 18 15:09:29.542 AST: %OIR-SP-6-INSCARD: Card inserted in slot 4, interfaces are now online

Patrick

3 REPLIES

Re: FWSM Blades Contantly running diagnostics.

This is not normal. What chassis & s/w versions do you have?

Re: FWSM Blades Contantly running diagnostics.

I was pretty sure that it was not normal. We are using it on a 6513 FWSM 2.3(3). We are looking at upgrading to 3.1. Although I need to check something else just found out that we had a 6748 blade die on us in that chassis so I guess I have more issues to resolve.

Patrick

Re: FWSM Blades Contantly running diagnostics.

yes, I'd check the chassis and supervisor out, I don't think it's a FWSM problem.

180
Views
3
Helpful
3
Replies