Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

FWSM failover question

I config FWSM failover. But why it diaplay "Interface outside (0.0.0.0)" when I enter "sh failover" command ?

thanks!

FWSM# sh failover

Failover On

Failover unit Secondary

Failover LAN Interface FAILOVER Vlan 910

Unit Poll frequency 1 seconds

Interface Poll frequency 15 seconds

Interface Policy 1

Monitored Interfaces 2 of 250 maximum

Last Failover at: 07:26:17 Dec 12 2005

This host: Secondary - Standby

Active time: 0 (sec)

Interface outside (0.0.0.0): Normal (Waiting)

Interface inside (0.0.0.0): Normal (Waiting)

Other host: Primary - Active

Active time: 1886 (sec)

Interface outside (10.1.255.3): Normal (Waiting)

Interface inside (98.1.1.3): Normal (Waiting)

2 REPLIES

Re: FWSM failover question

Hi

Can you revert whether you have configured the standby FWSM module also have u checked up for the ios codes in both the modules ?

is it possible to check whether the standby module is deteced and ready (on state)?

you can check out with show monitor-interface command also to verify the active/standby itnerface status..

for more info on the same do refer this link ..

http://www.cisco.com/en/US/partner/products/hw/switches/ps708/products_module_configuration_guide_chapter09186a00802010c0.html#wp1076500

regds

New Member

Re: FWSM failover question

I got it. I need config "ip address ... standby"

thanks!

129
Views
0
Helpful
2
Replies
CreatePlease to create content