If you have icmp enabled on the outside interface of a transparent context, should the FWSM show up in an icmp-based traceroute to an inside host? My guess is "no" for either udp- or icmp-based traceroute, but it sure would be handy if there were some kind of switch to allow this behavior. Does "inspect icmp" provide this? Thanks for any insight.
We have configured the outside and inside Interface with official ipv6 adresses, set a default route on outside Interface to our router, we also have definied a rule , which also gets hits, to permit tcp from inside Interface to any6.
In Syslog I also se...