Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

GRE IPSEC

Hello,

I have a problem in encrypt a mGRE tunnel between two 7609 routers.

Here you have the configuration:

crypto keyring key1

pre-shared-key address 0.0.0.0 0.0.0.0 key cisco

!

crypto isakmp policy 1

authentication pre-share

group 2

lifetime 14400

crypto isakmp aggressive-mode disable

crypto isakmp profile isakmp_data

keyring key1

match identity address 0.0.0.0

!

!

crypto ipsec transform-set gre esp-des

mode transport

no crypto ipsec nat-transparency udp-encaps

!

crypto ipsec profile tp

set transform-set gre

set isakmp-profile isakmp_data

...........

interface Tunnel100

bandwidth 1000000

ip address 4.x.x.1 255.255.255.252

no ip redirects

ip mtu 1416

ip nhrp authentication test

ip nhrp map multicast dynamic

ip nhrp network-id 100000

ip nhrp holdtime 600

ip ospf network broadcast

ip ospf priority 2

delay 1000

tunnel source ATM4/0/0.2

tunnel mode gre multipoint

tunnel key 100000

tunnel protection ipsec profile tp

crypto engine slot 3/0

The mGRE tunnel is up and running but I cannot establish the ISAKMP SA

If you have some ideeas about this issue, would be helpful.

Regards,

Alexandru Nitulescu

2 REPLIES
Bronze

Re: GRE IPSEC

The following URL will help you:

Configuring Dynamic Multipoint VPN (DMVPN) using GRE over IPSec between Multiple Routers

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008014bcd7.shtml

Configuring an IPSec Tunnel to Route Through a Hub and Multiple Remote Sites :

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009438e.shtml

Community Member

Re: GRE IPSEC

That's a bit odd, what should happen is that the IPSec conn should come up, and *then* the mGRE tunnel should come up.

What's the output of:

- sh crypto isakmp sa

- sh crypto ipsec sa

While trying to bring the link up, what's the output from

- debug crypto isakmp

- debug crypto ipsec?

532
Views
0
Helpful
2
Replies
CreatePlease to create content