I am trying to set up a GRE tunnel so I can send routing updates and QOS between sites. Right now, we have a 2611XM and an 871W. How can I configure this if the 871W router is using DHCP for the WAN (2611XM is a static address)? I'm suck trying to figure out what to do for the "tunnel destination" on the 2611XM.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...