Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

Has anybody did a NFuse installed on a DMZ web-server?

We tried to install a NFuse Citrix on a DMZ web-server. We open ICA UDP and TCP ports (UDP 1604 and TCP 1494). Also the TCP 80 ports for HTTP traffic from DMZ back to inside server.

We have been able to make it to work.

Does anybody has a suggestion to help?

Thanks

Eddy

1 REPLY
New Member

Re: Has anybody did a NFuse installed on a DMZ web-server?

You are probably using NAT and the application is having problems with that. Check with your application vendor and see if they support NAT. Before doing that, open all ports (ip any any) and see if that does it. That will take the PIX out of the picture. Then set a NON-NAT static (you may need to re-think your numbering & design and/or add a router to the DMZ to make this work). If that works, you’ll know it’s a problem with NAT for sure. Citrix Winframe didn’t work in a NAT environment for a long time then they finally came out with a patch.

123
Views
0
Helpful
1
Replies
CreatePlease to create content