Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Help !! IDS 4235 Disk Problem.

Hi,

My IDS 4235 have a error message during bootup :

WARNING : Drive on ch A, SCSI ID: 0 had exceeded Failure Prediction Threshold! Please make backup as soon as possible. Press any key to continue.

I try to press Ctrl-A to run the SCSI disk utility and verify Disk Media for this H/D, this H/D is ok. then I try to format this H/D,

after success, I reboot this IDS appliance, but the error message still occur.

Please give me some advise to resolve this problem.

Best Regards,

Jackson Ku

1 REPLY

Re: Help !! IDS 4235 Disk Problem.

I am not familiar with any bugs that cause this message so I would take it at face value. It's a bad hard drive. If you have a SmartNet on it you can call TAC and get a replacement but you can usually just replace the hard drive yourself and you should be fine. I have done this myself a few times and have had no problems. If yout go that route I would get the exactsame HD as whats in the unit or at least as close to it as you can get but I don't think this solution it supported by TAC

118
Views
0
Helpful
1
Replies