Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Help! PPPoE in PIX failover

Hi, my internet is a IP-8 PPPoE session. Now I try to install PIX515E failover but don't know how to config. If I use fix IP there is no default gateway in PPPoE setting. Somebody can help me?

3 REPLIES
New Member

Re: Help! PPPoE in PIX failover

Hello Amigo.

one of the failover requirements is to have static ip's configured. PPPOE is a dynamic way to get ip's, therefore failover will not support this.

New Member

Re: Help! PPPoE in PIX failover

You will need ASA ver 7.2 in order to do PPPoE. Also if it is a dynamic PPPoE connection, you may need the "setroute" command to set default route. See example below for dynamic PPPoE:

interface Ethernet0/0

nameif outside

security-level 0

pppoe client vpdn group bellsouthDSL

ip address pppoe setroute

!

vpdn group bellsouthDSL request dialout pppoe

vpdn group bellsouthDSL localname cisco@bellsouth.net

vpdn group bellsouthDSL ppp authentication pap

vpdn username cisco@bellsouth.net password 7779311

New Member

Re: Help! PPPoE in PIX failover

Thanks you very much! Because upgrade to high version is the next project so I will ask vender to change pppoe to fixed IP. Thanks!

165
Views
0
Helpful
3
Replies