Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 

Help with EasyVPN

Hi all,

I have created easy VPN with ASA5505 at BO and 3000 concentrator at HQ. Everything works great, but when the BO ASA reboots, it looses the 'Vpnclient enable' command (even after write mem) and adds the below commands:

nat (INSIDE1) 0 _vpnc_nwp_acl

aaa authentication listener http INSIDE1 port www redirect

aaa authentication listener https INSIDE1 port 1443 redirect

Unless I remove all these commands (see below) , Iam unable to enable 'vpnclient enable' command.

****************************************

HOMETEST(config)# vpnclient enable

* Remove "nat (INSIDE1) 0 _vpnc_nwp_acl"

* Remove 'aaa authentication listener' configuration

*****************************************

The ASA5505 has a Base license.

Please advise.

Thank you

MS

2 REPLIES

Re: Help with EasyVPN

Hi All,

I just found the reason for "aaa authentication listener' commands. This is bug in the sw. Bug ID: CSCsh75977.

Need to upgrade/dopwngrade software, then have to check on other thing {nat (INSIDE1) 0 _vpnc_nwp_acl }

Thank you

MS

Community Member

Re: Help with EasyVPN

It's a known bug in 7.2

http://www.cisco.com/cgi-bin/Support/Bugtool/onebug.pl?bugid=CSCsh75977

I upgraded to v8 and all is well.

Tony

158
Views
0
Helpful
2
Replies
CreatePlease to create content