Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

Help with Interface problem

Hi

I have a two pix's in in active/standy by configuration. Sometime early last week the active pix went down and the standby took over.

The problem is there's no apparent reason for it to go down. If I do "show interface" on the active pix, I get:

interface ethernet0 "out" is down, line protocol is up

Could someone please let me know why it would be down and how to bring it up again?

Thanks in advance

Dan

1 REPLY

Re: Help with Interface problem

Hi,

This probably indicates problem with physical interface, as normally, it should be up even if after you enable the interface without any cable connected to it.

You may need to open case on this.

Rgds,

AK

93
Views
0
Helpful
1
Replies
CreatePlease to create content