Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

help with pix config

hello i want to use a pix 506e to create at minimum 20 site to site tunnels that will all end at linksys rv042s that the 20 coustermers have. the website says it is possible to have up to 25 tunnels and the remaining tunnels i would like to use to host remote access clients. i would like to use a wheel and spoke topology where all the tunnels would terminate at the pix device, no certifactes, no authentication(radius or aaa) is this possible and if it is can u please direct me to more information for the configuration. thanks for ur time

1 REPLY
Silver

Re: help with pix config

This document demonstrates how to configure a Cisco VPN Client to connect to the inside of one PIX while connected via tunnel to another PIX. This is accomplished by terminating the tunnel on a different interface on the PIX to which the VPN Client is already connected.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a0080103ed0.shtml

94
Views
0
Helpful
1
Replies
CreatePlease login to create content