Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

New Member

How can I disable vendor ID in VPN 3030?

We can establish a VPN tunnel between a Cisco VPN 3030 (sw v4.0) and a Nortel Contivity (Extranet Switch 1700 with S/w Ver: V04_80.124) if the tunnel is initiated from the Nortel box. If the Cisco starts the VPN tunnel then we get the following in the Cisco 3030:

non-routine Notify message: Invalid ID info (18)

I've been advised by the Nortel to disable the vendor ID in the Cisco but can't find it.

Any help with any of the above is greatly appreciated.

2 REPLIES
Bronze

Re: How can I disable vendor ID in VPN 3030?

Hi Darius. As per my info, for concentrator to Contivity VPN to work, the vendor ID checking needs to be disabled on the Nortel box. Additionally, PFS group 2 checking needs to be disabled too. Please could you cross-check this.

New Member

Re: How can I disable vendor ID in VPN 3030?

Thanks for your advise. The othere side have confimed again today that both "Vendor id" and PFS are disabled.

314
Views
0
Helpful
2
Replies
CreatePlease to create content