Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

how configure FWSW 's transparent Mode?

thank you

2 REPLIES
Silver

Re: how configure FWSW 's transparent Mode?

Hello,

Not sure if you are looking for any specific clarifications on the trasnparent mode, but as far as FWSM concerns, configuration for FWSM is the same, regardless of which mode you use. Please, refer to the following link -

http://www.cisco.com/en/US/products/hw/switches/ps708/products_installation_and_configuration_guide_chapter09186a0080159cac.html#1066911

Regards,

Mynul

Community Member

Re: how configure FWSW 's transparent Mode?

thank you very much.

but i know the netscreen ' trasnpaarent mode is very easy,you set a manager ip only.

i dont' know the FWSM as same as the netscreen.

104
Views
0
Helpful
2
Replies
CreatePlease to create content