Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

How do I make an internal address appear on the outside as a specific routable address?

I have a PIX 525 with 6.01. I have

an inside subnet say 10.0.1.0 /24 and

an outside subnet say 208.0.1.0 /24.

How do I make certain host on the inside

network appear to the outside world

as a certain address on the 208 net?

So when an inside host,10.0.1.100 makes

a connection to the outside world,

say a ftp server, its address appears

as a specific 208 address,208.0.1.100, to that outside ftp server.

1 REPLY
Anonymous
N/A

Re: How do I make an internal address appear on the outside as a

The command does the job. Additionally, release 6 uses PDM which I think is a very helpful GUI tool in order to configure your PIX if you are not so experienced.

87
Views
0
Helpful
1
Replies
CreatePlease to create content