I have an asa cluster, and saved the config on disk0 once a week.
Now I would like to replay the config from last week, but it doesn ?t work.
I thought when I configure the boot config statement pointing to the old config on disk0 it should work. but ist doesn ?t. The Secondary takes over, and then the Primary comes back, but with the old config.
Disconnect the command switch from the member switches and physically remove it from the cluster. Insert the member switch in place of the failed command switch, and duplicate its connections to the cluster members. Start a CLI session on the new command switch.
Table of ContentsIntroductionVersion HistoryPossible Future
UpdatesDocuments PurposeNAT Operation in ASA 8.3+ SectionsRule Types
Network Object NATTwice NAT / Manual NATRule Types used per SectionNAT
Types used with Twice NAT / Manual NAT and Network Obje...
Table of Contents Introduction:This document describes details on how
NAT-T works. Background: ESP encrypts all critical information,
encapsulating the entire inner TCP/UDP datagram within an ESP header.
ESP is an IP protocol in the same sense that TCP an...