cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
247
Views
0
Helpful
1
Replies

How do I use Cisco MARS to monitor two FWSMs in two Cat6500 in failover ?

jscensny
Level 1
Level 1

Hello,

I understad that I can add both Catalysts to MARS and that I can add primary FWSM as a module to primary catalyst as well. But how can I add secondary FWSM.

Any ideas appreciated

Thanks

1 Reply 1

Not applicable

If you have already configured the primary, you don't have to configure the secondary. No need to configure the secondary as it is not recommended to do so, In case of a failover the secondary firewall will automatically take over the active configuration( EX: IP address) of the primary so the source of the syslogs will remain the same

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: