There is a sequence number with named ACL. I can use the sequence number to add new ACL entry in the current ACL.
But I notice it does not allow me to put "remark". We use "remark" in ACL to section the ACl to make it more logically.
Ext Access List configuration commands:
<1-2147483647> Sequence Number
default Set a command to its defaults
deny Specify packets to reject
dynamic Specify a DYNAMIC list of PERMITs or DENYs
evaluate Evaluate an access list
exit Exit from access-list configuration mode
no Negate a command or set its defaults
permit Specify packets to forward
remark Access list entry comment
R1-3640-WAN(config-ext-nacl)#10 ?
deny Specify packets to reject
dynamic Specify a DYNAMIC list of PERMITs or DENYs
evaluate Evaluate an access list
exit Exit from access-list configuration mode
permit Specify packets to forward
See "remark" is not under "sequence". Why ?
Any workaround ?
Thank you in advance.