Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

how to assign IP address through CSNT?

how to set NAS and CSNT? can someone give a example or advice? In CSNT, it seems simple. but it don't work, I still should use local pool of NAS. I think I lost some commands in NAS.

Does someone know how to do that? Any advice is appreciated.

1 REPLY
New Member

Re: how to assign IP address through CSNT?

At last I succeeded when using TACAS+ and IOS RADIUS. I used to use IOS Radius, always failed, but I just change to TACAS+, didn't chang other config of NAS, I succeeded.

At last I found even you use IOS RADIUS(CSACS 3.0), you still should set IETF

RADIUS: Service-Type=framed, Framed-Protocol=ppp. Tried again, and succeeded.

90
Views
0
Helpful
1
Replies