Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

How to change the interface for the "interface traffic usage" graph in ASDM

I have an ASA 5510 and have recently added a second (primary) internet connection and have an older DSL line which I now intend to use as a backup connection. Planning ahead for this, I put the DSL on interface 0/1 and the T1s are on 0/0. Unfortunately, the handy graph on the home page of ASDM is locked to the "DSL-Outside" interface (0/1) and I can't seem to find any way to change it to the "T1-Outside" interface (0/0). Is there any way to do this? (perhaps a command-line incantation?)

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: How to change the interface for the "interface traffic usage

It depends on the security level of the interface. The graph will show the interface with the lowest level. If there are 2 interfaces with the same security level then it will go alphabetically.

Please rate if this helps.

2 REPLIES
New Member

Re: How to change the interface for the "interface traffic usage

It depends on the security level of the interface. The graph will show the interface with the lowest level. If there are 2 interfaces with the same security level then it will go alphabetically.

Please rate if this helps.

New Member

Re: How to change the interface for the "interface traffic usage

Worked great - thanks!

174
Views
5
Helpful
2
Replies
CreatePlease to create content